DURKOPP ADLER 367 - INSTRUCTIONS FOR FITTING FOR KIT 0367 595144 Manual de Instruções descarregar pdf (Página 18)

2. Fitting

Caution: Danger of injury!

Switch off the main switch and pull out the mains plug before you

start to install the pneumatic foot lift. The installation must be done

by qualified technicians only.

–

Tilt the sewing machine to the back.

–

Loosen the 6 screws of the oil pan and take the oil pan off.

2.1 Replace the slide bar by a cylinder

–

Remove the locking washer 3from the right end of the slide bar 2

and the screw 1 from the left end of the slide bar 2.

–

Removetheslidebar2 from the finger on the right.

–

Run the hose 6 through the fixture 5 at the rear panel of the

machine.

–

Push the hose 6 on the connection 8 of the cylinder 4.

–

Fit the cylinder 4 instead of the slide bar 2. The piston must show

to the right and the throttling screw 7 must show down.

Ifyouturnthethrottlingscrew7 counter-clockwise, the piston is

moving more quickly. The sewing foot is lifted more quickly.

Ifyouturnthethrottlingscrew7 in clockwise direction, the piston

is moving more slowly. The sewing foot is lifted more slowly.

–

Put the locking washer 3 on the right of the cylinder 4 again and

screw in screw 1 on the left again.

–

Run the hose 6 to the right at the rear panel of the machine. Run

the hose outside through the cut-out 9 down on the right of the

sewing machine.

12 3

14536

1 2 ... 13 14 15 16 17 18 19 20 21 22

Sem comentários

DURKOPP ADLER 367 - INSTRUCTIONS FOR FITTING FOR KIT 0367 595144 Manual de Instruções Página 18